ooni-gorgias logo
ooni-gorgias logo

All articles

My Ooni Koda 16 isn’t getting hot enough after converting to natural gas.Updated 7 months ago

If your Ooni Koda 16 isn't getting hot enough after converting to natural gas,

follow the steps below. Note: these are instructions if you have installed the

[Natural Gas Conversion Kit](https://ooni.com/products/ooni-natural-gas-

conversion-kit?_pos=3&_sid=6547e4be5&_ss=r), not the Ooni Koda 16 Natural Gas

Line oven.




**Step 1. **Check that the correct nozzles have been installed - the nozzles

should have '1.75mm' imprinted on them.




**Step 2. **If the correct nozzles are present, make sure there are no leaks

in your gas hose by using a leak detector spray or by using soapy water (full

instructions on how to do a gas leak test

[here](https://ooni.kustomer.support/en_us/how-do-i-perform-a-gas-leak-test-

BJdijR_zj)).



**Step 3.** Make sure your infrared thermometer gun is set to the correct

emissivity level to ensure the correct temperature is recorded. Ooni infrared

thermometers are pre-set, so these will be accurate and cannot be adjusted. If

it's not an Ooni infrared thermometer gun, make sure the emissivity level is

set to 0.95. Make sure the infrared thermometer gun is held close enough when

recording the temperature. Hold it 6 inches (15cm) from the mouth of the oven.

Was this article helpful?
Yes
No